Reply to thread

Message

<blockquote data-quote="SLE" data-source="post: 324313" data-attributes="member: 3889">I have 26 internal combustion engines at my house, some that are just a PIA and messy to change oil and some that require extraction (jet ski). I used a small cheapy hand pump for the last several years only on the stuff I absolutely had too because it was slow, just as messy, and generally just kind a of a thorn in my side to use. I finally broke down and ordered a JohnDow JDI-6EV last winter, It's the cats a$$! I now use it to extract oil on things that have a drain plug and then pull the plug for the last few drips. It works great. I did add a low pressure regulator to the discharge side as your only suppose to discharge the oil with 5-7 psi and I didn't want to always be cranking on my main regulator on my compressor. Heck, I'm not sure that one would even go down to 5 psi. I added quick coupling air chucks to both the extraction and discharge side and that was it. Very well built and thought out and comes with 6-8 different types of extractor tubes. Two thumbs up on this product for anyone that needs a decent fluid extractor.<a href="https://www.johndow.com/product/6-20-gallon-fluid-evacuators/" target="_blank">https://www.johndow.com/product/6-20-gallon-fluid-evacuators/</a></blockquote>

[QUOTE="SLE, post: 324313, member: 3889"] I have 26 internal combustion engines at my house, some that are just a PIA and messy to change oil and some that require extraction (jet ski). I used a small cheapy hand pump for the last several years only on the stuff I absolutely had too because it was slow, just as messy, and generally just kind a of a thorn in my side to use. I finally broke down and ordered a JohnDow JDI-6EV last winter, It's the cats a$$! I now use it to extract oil on things that have a drain plug and then pull the plug for the last few drips. It works great. I did add a low pressure regulator to the discharge side as your only suppose to discharge the oil with 5-7 psi and I didn't want to always be cranking on my main regulator on my compressor. Heck, I'm not sure that one would even go down to 5 psi. I added quick coupling air chucks to both the extraction and discharge side and that was it. Very well built and thought out and comes with 6-8 different types of extractor tubes. Two thumbs up on this product for anyone that needs a decent fluid extractor. [URL]https://www.johndow.com/product/6-20-gallon-fluid-evacuators/[/URL] [/QUOTE]

Verification

What is the most common fish caught on this site?

Reply to thread

Recent Posts

Friends of NDA