Remodeling Ice House

[shep07]

I purchased a 8X12 ice house last year and was going to tear out the old plywood walls and ceiling and replace it with something more water resistant and easier to clean. The walls right now are just 1/4in plywood painted white so they are hard to clean especially after a day of spearfishing when the walls get covered in slime. Was looking at the enamel coated paneling figured that would shed some of the water and clean up easy. What do you guys use or have any better suggestions for finishing out the inside of an ice house?

 

[Apres]

Could you glue the FRP panels (milkhouse bd)over top of the plywood that's there? Not sure if that stuff shrinks with cold hot cycles though. But if you got it sealed up well you could literally pressure wash the inside out if you wanted. if the the enamel coated paneling you speak of is just white hardbd paneling, that stuff soaks water up and mushes really easy even if it's just a deep scratch it will look bad in a year. White tin liner panels are always a good idea.

 

[eyexer]

fiberglass panels for sure. white steel would work too.