K Drill on a digger auger rack?

[Jigaman]

Really thinking about going to a K drill but am wondering if it will work on my digger auger rack I have on my snowmobile. Anybody have this combo?

 

[guywhofishes]

Really thinking about going to a K drill but am wondering if it will work on my digger auger rack I have on my snowmobile. Anybody have this combo?

good question - took me a while to figure out how to make it work on the Johnson Cargo rack

 

[Jigaman]

good question - took me a while to figure out how to make it work on the Johnson Cargo rack

Do you have a picture of it on your JCR? Also considering going that route.

 

[Vollmer]

Buddy runs one on a homemade digger rack. Sits on there fine.

 

[Kickemup]

Only thing that might give it problems is the shaft size. The kdrill is about double the size of a normal auger.

 

[AaronJ]

Yes, they work just fine. Actually better than my Nils/Tanaka combo.

 

[SDMF]

Nils/Tanaka combo.

Nils Tanaka combo:

Wasabi drizzled Lutefisk with rice and soy sauce wrapped in a warm Lefse shell.

 

[VMAX]

Did Rodney Carrington say that?

Nils Tanaka combo:

Wasabi drizzled Lutefisk with rice and soy sauce wrapped in a warm Lefse shell.

 

[SDMF]

Nope, I just made it up.

 

[Jigaman]

Yes, they work just fine. Actually better than my Nils/Tanaka combo.

So I purchased the 8" k drill and I cant get it to work with the digger rack. The shaft size of the k drill is much larger than most augers and is causing an issue as kickemup mentioned. anyone have any ideas for me? My back up plan is to use the gun rack style that mounts to the atv rack but would much rather use my digger.

 

[mcfuch]

So I purchased the 8" k drill and I cant get it to work with the digger rack. The shaft size of the k drill is much larger than most augers and is causing an issue as kickemup mentioned. anyone have any ideas for me? My back up plan is to use the gun rack style that mounts to the atv rack but would much rather use my digger.

I know this is old, but I have the same problem. I just designed and 3D printed a new cradle cap to fit the K-Drill. The flighting of the K-Drill is kind of wonkey so the final version of this part is not ideal, but works.
https://makerworld.com/en/models/21...-carrier-k-drill-cradle-cap#profileId-2331084