Home made rod holder extensions

huffranger

Founding Member
Founding Member
Joined
Apr 19, 2015
Posts
2,023
Likes
44
Points
251
Location
Huff
I made these after seeing this picture on another forum

IMG_2729.jpg

I ordered the extra mounts off Ebay http://www.ebay.com/itm/RAM-Mount-R...292?pt=LH_DefaultDomain_0&hash=item58bd6051e4

I cut the short extensions in 1/2 and used a hole saw without the pilot bit to shape the ends to fit in the Aluminum pipe I bought at MAC's. Still had to tune up the ends little bit with the belt sander before they fit properly.

A little epoxy and a SS screw on each end finished them up.

IMG_2776.jpg IMG_2774.jpg

Can't wait to get out crankin !!!
 


huffranger

Founding Member
Founding Member
Thread starter
Joined
Apr 19, 2015
Posts
2,023
Likes
44
Points
251
Location
Huff
This is how they work

Boring video but here ya go !!

 

huffranger

Founding Member
Founding Member
Thread starter
Joined
Apr 19, 2015
Posts
2,023
Likes
44
Points
251
Location
Huff
Why don't u just point the rear rod straight back?


I do when I run 6 or 8 rods but in the vid I was pulling the boards through less than 8 FOW

i was targeting a shelf for an evening bite.
 


Recent Posts

Friends of NDA

Top Posters of the Month

  • This month: 6
  • This month: 5
  • This month: 5
  • This month: 4
  • This month: 4
  • This month: 4
  • This month: 3
  • This month: 3
  • This month: 3
  • This month: 3
Top Bottom