Barrel threading in the FM area?

[Norske]

Severance does very nice work. He's a good machinist and tech schooled gunsmith. He was recommended to me by L&M (he's retiring).

 

[PrairieGhost]

I need to sack up save the money and get suppressed.

10.5 gr of Trail Boss and a 140 gr bullet will give you 1030 fps and sound will be a little less than a Red Rider BB gun.

 

[Bed Wetter]

Update: I took it to Severance Shooting Solutions in Wyndmere.
He's a pretty straight-shooter (pun?), did a great job, and the turnaround was 13 days.
He cut the barrel down to 24in (my request), and threaded it 1/2 x28. Put a 5/8 x24 adapter on it to get it to 30 cal threads.

Here's the completed setup:

Nice scope ;-) Just ordered the same one for my new rifle. 4-24x was a little big but I think the 3-18x is going to be awesome at just 20oz.

 

[SDMF]

Update: I took it to Severance Shooting Solutions in Wyndmere.
He's a pretty straight-shooter (pun?), did a great job, and the turnaround was 13 days.
He cut the barrel down to 24in (my request), and threaded it 1/2 x28. Put a 5/8 x24 adapter on it to get it to 30 cal threads.

Here's the completed setup:

He put the bolt on the wrong side.

 

[Bed Wetter]

Update: I took it to Severance Shooting Solutions in Wyndmere.
He's a pretty straight-shooter (pun?), did a great job, and the turnaround was 13 days.
He cut the barrel down to 24in (my request), and threaded it 1/2 x28. Put a 5/8 x24 adapter on it to get it to 30 cal threads.

Here's the completed setup:

He put the bolt on the wrong side.

You're on a roll today. What was in your coffee this morning?