New ice fishing heater?

[wslayer]

Years ago i only had a coleman white gas lantern for my heat source and liked it,no inexpensive option for heat. Now these heaters,sunflowers put out to much heat in a two man.

Those were very nice, burned the eyes a bit but put out some nice heat. I had 2 propane lights in my big fish house, they almost put out enough to heat it. Had to be very gentle with the mantels after they we're burnt off.

 

[wslayer]

I’ve been eyeballing them for years

What are you using yours for and how did you set yours up? (how did you port the hot air into the shelter, etc.)

Still have great interest in them also. Wonder how long they would run off an ATV type battery when out ice fishing? I suppose would need to put the heat tube through another type tube so didn't burn the hub/flip over material when slid thru or under?

 

[guywhofishes]

they make easy to install “tent adapters” for venting wood stoves in wall tents etc.

can’t remember the term for them

 

[riverview]

Those were very nice, burned the eyes a bit but put out some nice heat. I had 2 propane lights in my big fish house, they almost put out enough to heat it. Had to be very gentle with the mantels after they we're burnt off.

when we first started with portables Colemen lanterns were pretty much the only option first gas then propane. I used to keep a few candles in ice house because the mantels were going to break.

 

[guywhofishes]

when we first started with portables Colemen lanterns were pretty much the only option first gas then propane. I used to keep a few candles in ice house because the mantels were going to break.

I remember those damn mantles breaking. Gaaaa!!!

 

[svnmag]

If y'all can blindfold some local women; for a moderate fee I'll walk in wearing gay shoes. Caveat: You might end up on the bottom.

 

[johnr]

That buddy heater issue is resolved with a little qtip of rubbing alcohol run down the flame hole.
Its not only a fix, but its cheap and fun.

 

[guywhofishes]

That burning feeling in yer pecker issue is resolved with a little qtip of rubbing alcohol run down the flame hole.
Its not only a fix, but its cheap and fun.

FIFY

 

[Davey Crockett]

My big buddy troubles went away after I raised the thermocouple up higher into the flame.